# This file (and the kernel config file accompanying it) are not designed 
# to be used by themselves. Instead, users of this file should create a
# kernel # config file which includes this file (which gets the basic hints),
# then override the default options (adding devices as needed) and adding
# hints as needed (for example, the GPIO and LAN PHY.)

# $FreeBSD: head/sys/mips/conf/QCA953X_BASE.hints 291438 2015-11-29 05:49:49Z adrian $

hint.apb.0.at="nexus0"
hint.apb.0.irq=4

# mdiobus on arge0 - required to bring up arge0
hint.argemdio.0.at="nexus0"
hint.argemdio.0.maddr=0x19000000
hint.argemdio.0.msize=0x1000
hint.argemdio.0.order=0

# mdiobus on arge1 - this is what the internal switch is hooked into.
hint.argemdio.1.at="nexus0"
hint.argemdio.1.maddr=0x1a000000
hint.argemdio.1.msize=0x1000
hint.argemdio.1.order=0

# uart0
hint.uart.0.at="apb0"
# see atheros/uart_cpu_ar71xx.c why +3
hint.uart.0.maddr=0x18020003
hint.uart.0.msize=0x18
hint.uart.0.irq=3

# ehci - on IP3
hint.ehci.0.at="nexus0"
hint.ehci.0.maddr=0x1b000100
hint.ehci.0.msize=0x00ffff00
hint.ehci.0.irq=1

hint.arge.0.at="nexus0"
hint.arge.0.maddr=0x19000000
hint.arge.0.msize=0x1000
hint.arge.0.irq=2

hint.arge.1.at="nexus0"
hint.arge.1.maddr=0x1a000000
hint.arge.1.msize=0x1000
hint.arge.1.irq=3

# XXX The ath device hangs off of the AHB, rather than the Nexus.
hint.ath.0.at="nexus0"
hint.ath.0.maddr=0x18100000
hint.ath.0.msize=0x20000
hint.ath.0.irq=0
hint.ath.0.vendor_id=0x168c
hint.ath.0.device_id=0x003d
# Set this to define where the ath calibration data
# should be fetched from in physical memory.
# hint.ath.0.eepromaddr=0x1fff1000

# SPI flash
hint.spi.0.at="nexus0"
hint.spi.0.maddr=0x1f000000
hint.spi.0.msize=0x10

hint.mx25l.0.at="spibus0"
hint.mx25l.0.cs=0

# Watchdog
hint.ar71xx_wdog.0.at="nexus0"

# The GPIO function and pin mask is configured per-board
hint.gpio.0.at="apb0"
hint.gpio.0.maddr=0x18040000
hint.gpio.0.msize=0x1000
hint.gpio.0.irq=2