# This file (and the kernel config file accompanying it) are not designed 
# to be used by themselves. Instead, users of this file should create a
# kernel # config file which includes this file (which gets the basic hints),
# then override the default options (adding devices as needed) and adding
# hints as needed (for example, the GPIO and LAN PHY.)

# $FreeBSD: head/sys/mips/conf/AR934X_BASE.hints 261871 2014-02-14 05:25:15Z adrian $

hint.apb.0.at="nexus0"
hint.apb.0.irq=4

# uart0
hint.uart.0.at="apb0"
# NB: This isn't an ns8250 UART
hint.uart.0.maddr=0x18020003
hint.uart.0.msize=0x18
hint.uart.0.irq=3

#ehci - note the 0x100 offset for the AR913x/AR724x
hint.ehci.0.at="nexus0"
hint.ehci.0.maddr=0x1b000100
hint.ehci.0.msize=0x00001000
hint.ehci.0.irq=1

# pci
hint.pcib.0.at="nexus0"
hint.pcib.0.irq=0

hint.arge.0.at="nexus0"
hint.arge.0.maddr=0x19000000
hint.arge.0.msize=0x1000
hint.arge.0.irq=2

hint.arge.1.at="nexus0"
hint.arge.1.maddr=0x1a000000
hint.arge.1.msize=0x1000
hint.arge.1.irq=3

# XXX The ath device hangs off of the AHB, rather than the Nexus.
hint.ath.0.at="nexus0"
hint.ath.0.maddr=0x18100000
hint.ath.0.msize=0x20000
hint.ath.0.irq=0
hint.ath.0.vendor_id=0x168c
hint.ath.0.device_id=0x0031
# Set this to define where the ath calibration data
# should be fetched from in physical memory.
# hint.ath.0.eepromaddr=0x1fff1000

# SPI flash
hint.spi.0.at="nexus0"
hint.spi.0.maddr=0x1f000000
hint.spi.0.msize=0x10

hint.mx25l.0.at="spibus0"
hint.mx25l.0.cs=0

# Watchdog
hint.ar71xx_wdog.0.at="nexus0"

# The GPIO function and pin mask is configured per-board
hint.gpio.0.at="apb0"
hint.gpio.0.maddr=0x18040000
hint.gpio.0.msize=0x1000
hint.gpio.0.irq=2